Filter
Top Products
D 14050.04
10.2007
14
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
Using the
Entrypoint
Viewing the
System Status
Configuring
the Entrypoint
Maintenance
& Upgrade
Services
Dial Plan
Examples
Contact
Information
To Get You
up and Going
TANDBERG ENTRYPOINT
USER GUIDE
The Entrypoint requires some basic
configurations before it can be used. It will be
necessary to find the IP-address and to create
the dial-in and dial-out services to program
the ISDN-PRI Line numbers.
Make sure the Entrypoint is Off and
connect an RS232 cable between the
Entrypoint and a PC.
Switch on the Entrypoint.
Start a terminal program on the PC and
configure it to:
115200, 8, 1, None
Configuring via the RS 232
To assign a static IP-address, type
Xconf ip Assigment: “Static”
and
Xconf ip address <IPAddr>
To assign an IP Subnetmask, type
Xconf ip address subnetmask
<subnetmask>
To assign an IP Gateway address, type
Xconf ip address gateway
<gateway IP-address>
Restart the Entrypoint.
Start a WEB browser
and enter the
IP-address of the
Entrypoint. Default
password: TANDBERG
Note the case sensitivity!
To configure the
Entrypoint for UMTS
dial-in, enter PRI or BRI
numbers and dial in
number(s). For details,
see Configuring the
Entrypoint.
To configure the Entrypoint for IP dial in, register the Entrypoint to a Gatekeeper and enter
H.323 services. For details, see Configuring the Entrypoint
As an alternative to the configuration via
RS 232 you may use the LCD panel to
configure and check the IP settings, as well as
to reboot the system. This is outlined on the
next page.
Power switch
Conguring Your Entrypoint via the RS 232
About Gateway Configuration
Configuration via the Front Panel