Filter
Top Products
Chapter 5 – AT Commands, S-Registers, and Result Codes
SocketModem Global MT5634SMI Developer’s Guide 24
Nn
Modulation Handshake
On
Return Online to Data Mode
P
Pulse Dialing
Qn
Result Codes Enable/Disable
Sr=n
Set Register Value
Sr?
Read Register Value
T
Tone Dialing
Vn
Result Code Format
Wn
Result Code Options
Xn
Result Code Selection
Zn
Modem Reset
&Cn
Data Carrier Detect (DCD) Control
&Dn
Data Terminal Ready (DTR) Control
&En
XON/XOFF Pass-Through
&Fn
Load Factory Settings
&Gn
V.22bis Guard Tone Control
&Kn
Flow Control Selection
&Ln
Leased Line Operation
&Pn
Pulse Dial Make-to-Break Ratio Selection
&Qn
Asynchronous Communications Mode
&Sn
Data Set Ready (DSR) Control
&Tn
Loopback Test (V.54 Test) Commands
&V
Display Current Settings
&Wn
Store Current Configuration
&Zy=x
Store Dialing Command
\An
Select Maximum MNP Block Size
\Bn
Transmit Break
\Kn
Break Control
\Nn
Error Correction Mode Selection
\Qn
Flow Control Selection
\Tn
Inactivity Timer
\Vn
Protocol Result Code
-Cn
Data Calling Tone
%A
Adaptive Answer Result Code Enable
%B
View Numbers in Blacklist
%Cn
Data Compression Control
%DCn
AT Command Control
%En
Fallback and Fall Forward Control
%Hn
Direct Connect Enable
%Rn
Cisco Configuration
%Sn
Command Speed Response
$EBn
Asynchronous Word Length
$Dn
DTR Dialing
$MBn
Online BPS Speed
$SBn
Serial Port Baud Rate
#CBAn
Callback Attempts
#CBDn
Callback Delay
# CBF?
Callback Failed Attempts Display
# CBFR
Callback Failed Attempts Reset
# CBIn
Local Callback Inactivity Timer
# CBNy=n
Store Callback Password
# CBPn
Callback Parity
# CBRy
Callback Security Reset
# CBSn
Callback Enable/Disable
#Pn
Set 11-bit Parity
#Sx
Enter Setup Password
#S=x
Store Setup Password
+VDR=x, y
Distinctive Ring Report
+++AT<CR>
Escape Sequence
%%%AT<CR>
Remote Configuration Escape Sequence
V.92 Commands