Filter
Top Products
4
GETTING STARTED
CONNECTING POWER
Before connecting the power, check that the mains voltage
on the rating plate of the AC adaptor is the same as the
voltage in your area.
Plug the DC cord from the AC adaptor into the DC In jack •
on the back of the unit.
Plug the AC adaptor into the wall socket and switch the •
mains power on.
The unit is now ready for use.
NOTE:- The AC adaptor may become warm during operation
- this is normal.
SETTING THE CLOCK
When the unit is switched on for the rst time, the clock
display will read 0:00.
To set the clock -
Press the • TIME button.
The hours digits will ash.
Press the• SET+/} or SET-/{ button to set the hours
digits to the correct time.
Press the • /, button when the hours setting is correct.
The minutes digits will ash.
Press the• SET+/} or SET-/{ button to set the
minutes to the correct time.
Press the • /, button when the minutes setting is
complete.
The time is now set.
If backup batteries have been tted, the correct time will be
maintained when the AC power is disconnected.
BACKUP BATTERIES
To t backup batteries:
Locate the backup battery compartment, underneath •
the base of the unit.
Slide o the battery cover.•
Fit 2 x AAA batteries, observing polarity. When replacing •
the batteries, use only the same AAA type specied.
Replace the battery cover.•
The backup batteries will ensure that the clock retains the
current time and alarm settings in the event of a power cut.
NOTE:- The backup batteries are only for backup purposes
and will not power the unit.
DISPOSAL OF BATTERIES
Dispose of used batteries with regard to the recycling
regulations in your area. Do NOT short circuit batteries or
throw them into water, the general rubbish or in a re.
Weak batteries can leak and damage the docking station.
Replace them in good time!