Filter
Top Products
2 Installation BCS II Simplex Repeater User Manual
2-2 Telect, Inc. 117209-1 A0
Location and Space
The BCS II Simplex Repeater module occupies one slot in any vertical
BCS II chassis or in the Vector chassis. Do not install more than five re-
peater modules in a BCS II chassis. The Vector Chassis can be fully
populated with repeaters. You must install two repeaters to complete
the cross-connect, one repeater for each network element.
Tools and Equipment
No special tools or equipment are required. Wear a grounding strap dur-
ing installation.
Power
–42 Vdc to –58 Vdc power reaches the module through the backplane
connector on the chassis. Power to the backplane connector block is de-
livered from the power distribution panel using 16–22 AWG wire. See
the chassis user manual for additional information on power transmis-
sion. Because the repeater is an active product, Telect recommends us-
ing a dual feed power source.
Technical Support (USA)
By e-mail: getinfo@telect.com
By phone: 888-821-4856 or 509-921-6161
INSPECTION
Compare the contents of the shipping container with the packing list.
Call Telect if you are missing anything.
NOTE
Telect is not liable for shipping damage.
If the shipping container is damaged, keep it for the carrier’s inspec-
tion. Notify the carrier and call Telect’s Customer Service Department:
1-800-551-4567 or 1-509-926-6000
Keep the container until you have checked equipment operation. If you
experience any kind of problem, call Telect’s Customer Service Depart-
ment. Use the original, undamaged container if you are instructed to re-
turn the product to Telect.