Filter
Top Products
4 Service BCS II Simplex Repeater User Manual
4-2 Telect, Inc. 117209-1 A0
4. When the LED snaps into place, the installation is complete.
5. To test the new LED, insert a plug into the “M” (monitor) jack.
The LED flashes for about 30 seconds, then lights steadily.
IN CASE OF DIFFICULTY
If problems occur after initial installation, check all cable connections
and the installation instructions in Chapter 2.
Technical Support
By e-mail: getinfo@telect.com
By phone: 888-821-4856 or 509-921-6161
IN-WARRANTY SERVICE
Contact your Telect equipment distributor, or call a Telect Customer
Service Representative:
1-800-551-4567
1-509-926-6000
Telect will repair or replace defective products within the limits of the
warranty. See “Repacking for Shipment” in this section.
NOTE
Call a Customer Service Representative for a Return Material Authori-
zation (RMA) before returning any equipment.
Flat surface of LED to
flat surface of socket
Leads
LED