Filter
Top Products
117209-1 A0 4-1
4 Service
CAUTION
!
CAUTION! This product must be installed and maintained
only by qualified technicians.
VORSICHT! Nur von qualifizierten Technikern installiert wer-
den und instand gehalten werden.
PRECAUCIÓN! Ser instalado y ser mantenido solamente por
los técnicos autorizados.
ATTENTION! Ce produit doit être installé et entretenu
uniquement par des techniciens qualifiés.
OWNER MAINTENANCE
Telect’s BCS II Simplex Repeater module does not need preventive
maintenance. The only part you can replace is the tracer lamp LED.
Replacing the Tracer Lamp LED
1. Pull the defective LED straight out with your fingers.
2. Align the replacement LED with the LED socket in the faceplate.
Notice that the socket is keyed, and the LED enters only one way.
ALERT
ALERT! Do not bend the LED’s two metal leads.
3. Gently insert the LED into the socket, as shown on the next page.
If you encounter resistance, do not force the LED into position.
Move it until it slides easily into the jack module.