Filter
Top Products
Teledex IP250D User’s Guide SIP/MGCP Part Number 600-0480-603
INSTALLING THE IP250D
2.2 UNPACKING THE IP250D
The IP250D VoIP network terminal package contains several components:
• The main base unit, sometimes referred to as the keyset
• A handset for use during conversations
• A desk/wall mount bracket, to support the keyset at a convenient angle on
the desk, or for mounting the phone on a vertical surface, such as a wall
• A network patch cable for connecting the keyset to the network
• A handset coil cord, to connect the handset to the keyset
• Package may also contain an optional power supply (if necessary)
2.3 CONNECTING THE HANDSET
Plug one end of the coil cord into the RJ-10 receptacle on the handset and the other end
into the receptacle on the left front side of the keyset. Place the handset into the cradle of
the keyset.
2.4 CONNECTING THE IP250D TO THE NETWORK
Warning! Risk of electrical shock! Dangerous voltages may be present on the terminals of
the network patch cable after it is plugged into the network wall jack. Connect the patch
cable to the keyset base first, then to the network wall jack.
Plug one end of the network patch cable into the RJ-45 receptacle labeled 10/100 SW on
the bottom of the IP250D keyset. Connect the other end of the cable to the network wall
jack (receptacle) designated by the network administrator.
Caution: Do not connect a telephone cord to the network RJ-45 jack. A standard RJ-11
telephone cord connector can fit into the RJ-45 jack, however there is risk of damaging the
equipment if this is done.
Note: The IP250D will not function until it has been configured and activated by the
network administrator.
2.5 CONNECTING A PC TO THE IP250D
If the office or cubicle space has only one active network receptacle, and another network
device such as a PC must share the same space, the PC should be disconnected from
the wall jack and reconnected to the RJ-45 receptacle on the bottom of the IP250D that
is labeled 10/100 PC.
!
WARNING