Filter
Top Products
Teledex IP250D User’s Guide SIP/MGCP
INSTALLING THE IP250D
4
Caution: The cable from the network wall jack must be connected to the connector marked
SW, and if there is a PC, it must be connected to the connector marked PC, otherwise the
IP250D will not function.
2.6 ARRANGING THE IP250D ON THE DESK
Route the network cable toward the rear of the keyset and attach the desk/wall
mounting bracket by inserting the snap fasteners into the matching holes in the base.
Place the unit at a convenient location on the desk. Be sure to replace the handset on the
cradle and ensure that the hookswitch is properly depressed by the weight of the earpiece
of the handset.
2.7 MOUNTING THE IP250D ON A WALL
The IP250D can be mounted on a wall or other vertical surface. To do so, the desk/wall
mounting bracket should be rotated 180 degrees, compared to the desk mounting
position. Use screws (and anchors, if necessary) to match the hole pattern in the bracket.
The wall mounting clip near the hookswitch should be removed and re-installed after
rotating it 180 degrees. To remove the clip, push it firmly toward the hookswitch.
The clip will hold the handset in the cradle and cause it to depress the hookswitch when
the phone is not in use.
2.8 CONNECTING A HEADSET TO THE IP250D
Two types of headsets may be connected to the IP250D:
a) The type that replaces the handset and connects to the RJ-10 handset cord receptacle
b) The type that connects to a 2.5 mm diameter jack (located on the right front side
of the keyset)
When using the 2.5 mm type, the handset should be left in the cradle, such that it
depresses the hookswitch. Please follow the headset manufacturer’s instructions when
using the type that replaces the handset.
Note: The handset, headset and speakerphone devices have special rules that describe their
modes of use, as described in section 4.7.