Filter
Top Products
5.5.2 Removing/Replacing PCMCIA Options
The procedure for removing and replacing the PCMCIA options is as follows:
1. Turn off the computer.
2. Press the associated PCMCIA Eject button (left button ejects the top
PCMCIA device, right button ejects the bottom device (see Figure 5-5).
3. Remove the PCMCIA device(s).
4. To replace the PCMCIA Device, open the cover door and insert the device.
Reinstall any external cabling required for the device.
5.5.3 Removing/Replacing the Keyboard
Assembly
The procedure for removing and replacing the keyboard assembly is as
follows:
1. Turn off the computer and close the cover; disconnect the ac power
adapter (if it is attached).
2. Slide the two cover release latches forward and open the notebook.
3. As shown in Figure 5-6, the top edge of the keyboard is held in place by
three pairs of plastic tabs. Insert a small straight slot screwdriver into
the slots along the top edge of the keyboard as shown in Figure 5-6.
Gently tilt the screwdriver forward and allow the keyboard to lift
upwards.
PCMCIA Eject Switches
PCMCIA Slots
Figure 5-5 PCMCIA Device, Removal/Replacement
5-10 Field Service