Filter
Top Products
SpeedTouch 210i
27
♦ Dial-In Service – Click Enable to allow dial-in service. Note that if you click
Disable, the router will not accept any in-coming ISDN calls.
PPP/MP Setup
♦ Dial-In PPP Authentication – There are two choices:
PAP - Selecting this option will force the router to authenticate dial-in
users with the PAP protocol.
PAP or CHAP - Selecting this option means the router will attempt to
authenticate dial-in users with the CHAP protocol first. If the dial-in user
does not support this protocol, it will fall back to use the PAP protocol for
authentication.
♦ Mutual Authentication (PAP) – Enable this only if the connecting router
requires mutual authentication. By default, the option is set to No.
♦ Username – Enter the mutual Authentication username.
♦ Password – Enter the mutual Authentication password.
IP Address Assignment for Dial-In Users
♦ Start IP Address – Enter a start IP address to be assigned to the dial-in PPP
connection. You should choose an IP address from the local private network.
For example, if the local private network is 192.168.1.0/255.255.255.0, you
can choose 192.168.1.200 to be the Start IP Address. Because one ISDN
BRI has two independent data channels (B-channels), it is possible to allow
two dial-in users at the same time. The first dial-in user would be assigned the
start IP address and the second would be assigned the start IP address plus 1.
Click OK.
Creating an Access Account for a Dial-in User
After activating the dial-in capability, you must create an access account for each dial-in
user. From the Advanced Setup menu, click Remote Dial-In User Setup to open the
page shown below. The router provides 10 access accounts for dial-in users.