Filter
Top Products
34
1600EP Series Instruction Manual
Data Setting Screens (Cont’d)
The following screens show the procedure for setting the data variables. They are accessed from the main
Data Setting screens (see page 33) when the SHIFT/SELECT key is pressed:
KEY LOCK: DIS
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
DEFAULT SETTINGS
PUSH: SELECT
KEY LOCK: EN
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
DEFAULT SETTINGS
PUSH: SELECT
Loops through both
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Key Lock data
setting screen page 33
BUZZER VOLUME: 2
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
BUZZER VOLUME: 2
TO ACCEPT: SET
BUZZER VOLUME: 1
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
BUZZER VOLUME: 1
TO ACCEPT: SET
Loops through three
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Buzzer data
setting screen page 33
BUZZER VOLUME: 0
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
BUZZER VOLUME: 0
TO ACCEPT: SET
LCD SLEEP: 3 MIN
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
LCD SLEEP: 3 MIN
TO ACCEPT: SET
LCD SLEEP: 30 MIN
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
LCD SLEEP: 30 MIN
TO ACCEPT: SET
Loops through both
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from LCD Display Time
data setting screen page 33
AUTO RUN: YES
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
AUTO RUN: YES
TO ACCEPT: SET
AUTO RUN: NO
TO CHANGE: SELECT
Shift
Select
Set
Monitor
+
AUTO RUN: NO
TO ACCEPT: SET
Loops through both
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Auto Run data
setting screen page 33
Key Lock function: Allows the operator
to disable the RUN + STOP button
functions. When this function is set to
EN the unit will remain in the operating
mode it was in when enabled and
will not be able to be changed with
the RUN + STOP buttons until this
function is disabled. With this function
set to DIS, the RUN + STOP buttons
function normally.
Default setting is DIS.
Buzzer:
2 = High
1 = Low
0 = Off
Default setting is 2 = High (loudest)
LCD Sleep: Displays the number of
minutes (3 or 30) of idle time before
the LCD will go blank (this is to prolong
LCD life). The LCD will be active again
once a display button is pressed.
Default setting is 3 MIN.
Auto Run: If set to YES, the unit will
automatically start up in the UPS
mode (on line) when input voltage is
applied, regardless of what mode it
was in when shut down.
Default setting is NO.