Filter
Top Products
38
1600EP Series Instruction Manual
Data Setting Screens (Cont’d)
The following screens show the setting procedure for setting the data variables. They are accessed from
the main Data Setting screens (see page 33) when the SHIFT/SELECT key is pressed:
VOLTAGE ADJ: +5
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
VOLTAGE ADJ: +5
TO ACCEPT: SET
VOLTAGE ADJ: -5
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
VOLTAGE ADJ: -5
TO ACCEPT: SET
Loops through
eleven possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Buzzer data
setting screen page 33
VOLTAGE ADJ: +4
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
VOLTAGE ADJ: +4
TO ACCEPT: SET
This parameter has no options to set.
A battery test will be performed once
the SHIFT + SET button is pressed.
If the BAT TEST INHIBIT message is
displayed, it indicates that a battery
test has been performed recently.
The UPS will not allow frequent bat-
tery tests to insure that the batteries
remain in a fully charged state.
This parameter allows the user to off-
set the output voltage (while the unit
is running on-lline) in 1% increments
over a range of +/-5% total offset.
Default value is 0%
This parameter has no options to set.
Pressing the SHIFT + SET button
while this message is displayed will
cancel timer settings.
BATTERY TEST
###%
Shift
Select
Set
Monitor
+
TO BEGIN: SET
Cont’d from Bat Test Interval
data setting screen page 33
BATTERY TEST
INHIBIT
OR
CLEAR TIMER SET
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
CLEAR TIMER SET
TO ACCEPT: SET
Cont’d from Clear Timer data
setting screen page 33
This parameter has no options to
set. Pressing the SHIFT + SET but-
ton while this message is displayed
will reset all variables to their default
value.
DEFAULT SETTINGS
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
DEFAULT SETTINGS
TO ACCEPT: SET
Cont’d from Clear Timer data
setting screen page 33
Executes battery test and returns
to Data Setting screens
Executes battery test and returns
to Data Setting screens
Executes battery test and returns
to Data Setting screens