Filter
Top Products
37
1600EP Series Instruction Manual
Data Setting Screens (Cont’d)
The following screens show the procedure for setting the data variables. They are accessed from the
main Data Setting screens (see page 33) when the SHIFT/SELECT key is pressed:
AUTO BATT TEST: NO
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
AUTO BATT TEST: NO
TO ACCEPT: SET
AUTO BATT TEST: YES
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
AUTO BATT TEST: YES
TO ACCEPT: SET
Loops through both
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Auto Batt Test data
setting screen page 33
If set to YES, the unit will perform a
periodic test at the interval set in the
Battery Test Interval parameter.
Default is NO.
INTERVAL: 1 DAY
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
INTERVAL: 1 DAY
TO ACCEPT: SET
INTERVAL: 99 DAY
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
INTERVAL: 99 DAY
TO ACCEPT: SET
Loops through 99
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Batt Test Interval
data setting screen page 33
INTERVAL: 2 DAY
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
INTERVAL: 2 DAY
TO ACCEPT: SET
The Battery Test Interval variable se-
lects the interval in days that the bat-
tery test will be conducted. The op-
tions cycle through 1 to 99.
Default is 1 day.
This parameter allows the correct
communication baud rate to be set.
Default is 9600 baud.
BAUD RATE: 1200
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
BAUD RATE: 1200
TO ACCEPT: SET
BAUD RATE: 9600
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
BAUD RATE: 9600
TO ACCEPT: SET
Loops through four
possibilities
Returns to Data Setting screens
(with new value applied)
Cont’d from Baud Rate data
setting screen page 33
BAUD RATE: 2400
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
BAUD RATE: 2400
TO ACCEPT: SET
BAUD RATE: 4800
TO CHANGE:SELECT
Shift
Select
Set
Monitor
+
BAUD RATE: 4800
TO ACCEPT: SET