Filter
Top Products
1. Remove two mask seals at the bottom corners of the
display assembly to expose two screws securing the
display mask.
2. Remove two M2.5x6 black screws securing the display
mask.
3. There are 23 latches securing the display mask.
Carefully insert your fingers between the display mask
and the LCD module and pry open the latches starting
from the seven bottom latches, to the five latches on
the right and left sides, ending with the six top latches.
FL INVERTER AND 13.3” LCD REMOVAL
1. Peel off the glass tape securing the FL cable.
2. Remove one M2x5 brass screw securing FL inverter
board.
3. Carefully lift up the FL inverter board and disconnect
the LCD/FL cable from CN1 and the FL cable
from CN2.
4. Remove four mask seals to expose four screws
securing the left and right LCD brackets.
5 Remove four M2X5 silver screws securing both
brackets.
6. Carefully rotate out the top of the LCD module
enough to access the display cable.
7. Peel off the tape securing the LCD/FL cable and
disconnect the cable.
8. Remove four M2x3 silver screws securing the left
and right LCD brackets.
FIELD REPLACEABLE UNIT DOCUMENTATION
Satellite
TM
1800 Series
TOSHIBA
Tough Enough for Today’s World
13.3” DISPLAY MASK REMOVAL
LCD module
FL inverter board
LCD/FL cable
FL cable
M2x3
silver
screws
M2x5
silver
screws
M2x5 brass
screw
Latch
Mask seals
Display
mask
LCD
Glass tape