Filter
Top Products
FIELD REPLACEABLE UNIT DOCUMENTATION
1800 Series
TOSHIBA
Tough Enough for Today’s World
COOLING MODULE REMOVAL
3. Remove four M2x16 brass screws securing the
cooling module.
4. Disconnect the fan cable from PJ770 from the
system board and lift out the Fan module.
Fan cable
PJ770
M2x16 brass screws
Cooling
module
5. Slide the CPU lock in the direction of the arrow.
6. Insert a 5mm flat head screwdriver on the top side
of the CPU socket and push the socket in the
direction of the arrow and lift out the CPU.
CD-ROM/DVD ROM DRIVE REMOVAL
1. Remove two M2x5.5 silver screws securing the CD-ROM/
DVD ROM drive.
2. Slide the CD/DVD-ROM drive to the right to disconnect
it from PJ321 on the system board.
CD/DVD-ROM drive
bracket
M2x2 silver screws
Brass washers
3. Remove two M2x2 silver screws and two brass
washers securing the CD/DVD- ROM drive bracket.
CD/DVD-ROM
drive
M2x5.5 silver screws
CPU
lock
CPU
Flat head
screwdriver
Silicone grease
Satellite
TM
.
NOTE: When installing the CPU make sure that a silicone
grease is applied before attaching the cooling
module. Please refer to FSB-200112 for the complete
procedures on how to apply the silicone grease.
CPU REMOVAL