Filter
Top Products
1 PREPARATION
36 Preparation 1 - Turning Power ON
Preparation 1 - Turning Power ON
Turning power ON
1
Press the power switch to “ ” (ON) side.
The equipment starts warming itself up. The warm-up time takes approx. 25 seconds.
When the warm-up has finished, the equipment is ready for copying. “READY” appears
on the LCD screen.
If you press the [START] button with an original placed while the warm-up is still continu-
ing, copying automatically starts after it has finished. This is called auto job start. When
the job is reserved, “Auto Start” appears on the LCD screen to show you the current sta-
tus.
However, this function cannot be accessed while “Please wait” is being displayed
(approx. 15 seconds).
2
The LCD screen below is shown if the equipment is managed under
the department code function. Key in the department code.
Key in a 5-digit department code, and then press the [ENTER] button. Then the
equipment is ready for copying.
If the department code function is enabled, press the [FUNCTION CLEAR] button after
any operation has been finished to prevent unauthorized use of the equipment.
For the details of the department code, see the following page:
P.143 “Department Code”
READY
1
100% NONSORT
ZOOM FINISHING EDIT
Enter DEPARTMENT CODE
1
100% NONSORT
Z
OOM
F
I
N
I
S
HI
NG
EDIT