Filter
Top Products
Changing the Paper Size of the Drawer and Adding Paper
5. Push the arrow part (left side) to lock the size
selection lever.
6. Place paper in the drawer(s).
y Place paper face up.
y Fan the paper well before placing it in the drawer.
y Do not add paper above the line indicated on
the guide.
y Do not use creased, folded, wrinkled or damp sheets
of paper.
OTE: Make sure that a gap of approx. 0.02” (less than
.
7. Push the drawer straight into the copier until it comes
TI when
8. Change the size mark plate to match with the size of
N
0.04” in total) is left between the paper and the side guide
If there is no gap, this could cause paper misfeeding.
to a stop. Be sure to push the drawer fully in.
P: Be careful not to let your fingers be caught
closing the drawer. This could injure you.
paper that has been set.
Page 22