Filter
Top Products
Turning the System On
1. Open the switch cover, and then turn ON the power switch.
“Wait Warming Up” appears on the Basic screen on the
touch panel.
2. About 25 seconds later, the equipment will be ready.
“READY” appears on the Basic screen.
TIPS:
y While the copier is warming up, you can use the Auto Job Start function.
y POWER FAILURE message: When restarting the equipment due to power failure, etc.,
“POWER FAILURE” appears at the upper right of the screen. To clear it, press the
FUNCTION CLEAR button twice. The job in progress at the time of the power failure
is deleted.
Turning the System Off
When turning off the power of the equipment, perform the following shutdown procedure.
DO NOT turn off the power by switching off the power switch of the equipment as it can cause
the failure of the hard disk
Before turning off the power, be sure that the following 3 conditions are satisfied:
y No jobs are left in the printing job list.
y None of PRINT DATA, MEMORY RX and Fax communication lamps is blinking.
y No PCs access the equipment via network.
1. Press the USER FUNCTIONS button on the control panel.
Page 2