Filter
Top Products
1 BEFORE USING EQUIPMENT
22 Placing Paper
y Paper in the right-hand tray is used first. When it runs out, paper in the left-hand tray will be moved
automatically to the right-hand tray and fed.
y A maximum of 2360 sheets (80 g/m
2
) (20 lb. Bond) can be placed in the 2 trays. However the stack height
of the paper must not exceed the line indicated inside the side guides.
P.11 “Acceptable copy paper”
y The copy side may be noted on its wrapping paper.
y Be careful not to cut your fingers when fanning the paper.
y When placing paper, be sure that the center lever is not open. (See the label attached in the Tandem Large
Capacity Feeder.)
3
Push the drawer of the Tandem Large Capacity Feeder straight into this equipment
carefully.
When the drawer is completely inserted, the right-hand tray will move up to the paper feeding position.
Do not slam the drawer shut. Stacked sheets may collapse and they cannot be transported correctly.
Be careful not to let your fingers be caught when pushing the drawer into this equipment.
This could injure you.
4
Change the paper type as required.
P.19 “Setting paper type”
Adding paper in the Tandem Large Capacity Feeder during copying
When the paper on the left tray of the Tandem Large Capacity Feeder has run out during copying, “Paper for left drawer
can be added.” appears. You can pull out the Tandem Large Capacity Feeder and add paper to the left tray without
stopping copying. This is useful when you wish to make a large amount of copies quickly.
1
Pull out the drawer of the Tandem Large Capacity
Feeder carefully until it comes to a stop.
Only the left tray will come out.
Do not touch the slide rail (“A” in the figure on the right).
This could injure you.
2
Place paper on the left tray.
Place paper aligning to the left-hand side of the tray.
A