Filter
Top Products
35
Setting up your computer and getting started
5.375 x 8.375 ver 3.1
Removing a memory module
If you need to remove a memory module:
1 Complete steps 1-8 in “Installing additional memory
(optional)” on page 31 to shut down the computer and
open the memory module slot cover.
Do not try to remove a memory module with the computer turned on.
You can damage the computer and the memory module.
Do not remove the memory module while the computer is in Standby
or Hibernation mode. The computer could hang up the next time you
turn it on and data in memory will be lost. In either of the above
cases, the Standby configuration will not be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any key to Continue
If the computer hangs up when you turn it on, perform the following:
Press the power button and hold it down for at least ten seconds,
then turn the power on again.
2 Pull the clips away from the memory module.
The memory module pops up slightly.
3 Gently lift the memory module to a 45-degree angle and
slide it out of the slot.
4 Replace the memory module slot cover and tighten the
screw.
5 Re-insert the main battery. For information on inserting
the main battery, see “Inserting a charged battery” on
page 47.
6 Turn the computer right side up.
7 Reconnect the cables.
8 Restart the computer.
TECHNICAL NOTE: You must have at least one memory module
installed for the computer to work.