Filter
Top Products
AR-B1375/AR-B1376 User s Guide
7-3
7.3 ADVANCED CMOS SETUP
The <Advanced CMOS SETUP> option consists of configuration entries that allow you to improve your system
performance, or let you set up some system features according to your preference. Some entries here are
required by the CPU board
s design to
remained in their default settings.
AMIBIOS SETUP - ADVANCED CMOS SETUP
(C) 1995 American Megatrends, Inc. All Rights Reserved
Pause on Config. Screen (Sec.) 2
BootUp Sequence C:,A:,CDROM
BootUp Num-Lock On
Floppy Drive Swap Disabled
Floppy Drive Seek Disabled
Typematic Rate Fast
System Keyboard Present
Primary Display VGA/EGA
Password Check Setup
Parity Check Disabled
OS/2 Compatible Mode Disabled
Wait For ‘F1’ If Error Enabled
Hit ‘DEL’ Message Display Enabled
Hard disk Delay 3 Sec
On Board Flash Disk SSD
C000, 32k Shadow Enabled
C800, 32k Shadow Disabled
D000, 32k Shadow Disabled
D800, 32k Shadow Disabled
E000, 32k Shadow Disabled
E800, 32k Shadow Disabled
Onboard IDE Enabled
Onboard FDC Enabled
Onboard Serial Port 1 3F8
Serial Port1 IRQ IRQ 4
Onboard Serial Port 2 2F8
Onboard Serial Port 2 IRQ IRQ 3
Onboard Parallel port 378
Parallel port Mode SPP
ECP DMA DMA 3
Parallel Port IRQ IRQ 7
Available Options :
Disabled
2
3
4
5
6
7
8
9
10
11
12
13
14
ESC:Exit ↑↓:Sel
PgUp/PgDn:Modify
F2/F3:Color
Figure 7-3 BIOS: Advanced CMOS Setup
BootUp Sequence
The option determines where the system looks first for an operating system.
BootUp Num-Lock
This item is used to activate the Num-Lock function upon system boot. If the setting is on, after a boot, the Num-
Lock light is lit, and user can use the number key.
Floppy Drive Swap
The option reverses the drive letter assignments of your floppy disk drives in the Swap A, B setting, otherwise
leave on the default setting of
Disabled (No Swap). This works separately from the BIOS Features floppy disk
swap feature. It is functionally the same as physically interchanging the connectors of the floppy disk drives. When
the setting is <
Enabled>, the BIOS will be swapped floppy drive assignments so that Drive A becomes Drive B,
and Drive B becomes Drive A under DOS.
Floppy Drive Seek
If the <Floppy Drive Seek> item is setting Enabled, the BIOS will seek the floppy <A> drive one time upon bootup.
Typematic Rate
This item specifies the speed at which a keyboard keystroke is repeated.