Filter
Top Products
2. SUPPLY SPECIFICATIONS EO10-33013B
(Revision Date: Apr. 24, 2008)
2.4 SPECIFICATION OF RFID TAG (for B-9704-RFID-U1-US/EU-R, H1-QM-R)
2- 8
(2) X-ident’s ISO 18000-6B Tag
It is recommended to locate the vertical center of an RFID tag in the area 40mm ±5mm from a leading
edge of a label and the horizontal center with the horizontal center of the label.
2.4.4 Cautions for using RFID Tags
(1) Lift-up of Print Head
An RFID tag chip or the print head may be damaged when the print head passes over the chip.
This can be prevented by using the ribbon saving module (standard feature for the B-SX5T and
optional for the B-SX4T). The print head is lifted by the ribbon saving module when it passes over the
chip to prevent it from touching the chip.
The print head is lifted by approximately 1 mm from the platen.
2) Storage of RFID Supplies
Do not store RFID tags close to printers, or their communication performance may not be as specified
when they are used.
3) Roll-type RFID Supplies
When RFID supplies are to be rolled, roll hardness must be concerned.
Although it depends on the type of glue, tag, and backing paper, RFID-tag embedded labels tend to
stay rolled. Especially, when they are wound outside, a media jam error may occur. Unless otherwise
specified, it is recommended that the RFID-tag embedded labels be wound inside.
4) Sensor
When the transmissive sensor or reflective sensor is enabled, transmissivity or reflectivity of a label or
tag may vary at an RFID-tag embedded area depending on the pattern of an antenna or other factors.
In such cases, a manual threshold setting is required in Online mode. For details, refer to the B-SX
Key Operation Specifications (TAA-1379).
40 mm + 5mm
Media feeding direction