Filter
Top Products
3. OPTIONAL KIT EO10-33013B
(Revision Date: May 22,2009)
3.10 RFID MODULE: B-SX704-RFID-U2-EU/AU/US-R
3- 5
3.10 RFID MODULE: B-SX704-RFID-U2-EU/AU/US/CN-R
Installing this module enables the printer to write data on an RFID tag as well as to print on the surface
of RFID supplies.
Applicable model:
(1) This optional device is intended for the following models:
B-SX4T-GS20-QM/CN-R and B-SX5T-TS22-QM/CN-R, RFID ready printer.
An RFID Ready printer can be identified by the model name sticker on the front of the printer.
Be careful not to install this product in the B-SX4T-GS10-QQ/QQ-US, B-SX5T-TS10-QQ/QQ-US,
B-SX4T-GS10-CN and B-SX5T-TS12-CN RFID Ready printers.
(2) To use this device, printer firmware V4.5 or greater is required. Upgrade the firmware to V4.5 or
greater, if necessary. For the downloading procedure, refer to the B-SX4T/SX5T Series Maintenance
Manual.
Note that a RAM clear needs to be performed after downloading, so print out the maintenance
counter and parameter settings prior to downloading. After performing a RAM clear, restore the
printer parameter settings to the former states.
(3) The countries where the use of this device is allowed are as follows:
Model Name Frequency Band Applicable Countries
B-SX704-RFID–U2-EU-R
UHF 869.7 to 870.0MHz
(Center frequency: 869.85MHz)
EU member states and EFTA member states
B-SX704-RFID–U2-AU-R
UHF 918.25 to 925.75MHz
(Center frequency: 922MHz)
Australia
B-SX704-RFID–U2-CN-R
UHF 920.625 to 924.375MHz
(Center frequency: 922.5MHz)
China
B-SX704-RFID–U2-US-R
(Serial Number:
2808Yxxxxxx and earlier)
UHF 902.75 to 927.5MHz
(Center frequency: 915.125MHz)
U.S.A., Canada
(4) As from the January 2009 production (Serial Number 2809Axxxxxx and after), the AU (Australia)
specification has been supported by the B-SX704-RFID-U2-US-R RFID Module. Also the KR (South
Korea) and TW (Taiwan) specifications have been added.
The firmware of the B-SX4T/SX5T-R series barcode printer should be V4.7 or greater. If V4.6A or
less, please install the firmware V4.7 into the printer.
Make sure the firmware version is V4.7 and greater when turning on the printer.
When the firmware version is V4.6A or less, it is necessary to upgrade the firmware to V4.7 and
greater. For the downloading procedure, refer to the B-SX4T/SX5T Series Maintenance Manual.
For the printer to which back side the sticker MAIN4-R is attached, the firmware V5.0 and greater has
been installed. Since the firmware V5.0 and greater is exclusive to this printer, do not install the
firmware V4.7 into it.
ONLINE V4.7