Filter
Top Products
3. OPTIONAL KIT EO10-33013B
3.1 CUTTER MODULE: B-4205-QM/QM-R (Swing Cutter), B-8204-QM/QM-R (Rotary Cutter)
3- 2
3.1 CUTTER MODULE: B-4205-QM/QM-R (Swing Cutter), B-8204-QM/QM-R
(Rotary Cutter)
This compact cutter module uses a built-in swing/rotary cutter. The specification is provided below:
Cutter Type B-4205-QM/QM-R B-8204-QM/QM-R
Cut method Stop and cut Rotary cut
B-SX4T 30.0 mm − 112.0 mm
Media width
B-SX5T 30.0 mm − 140.0 mm 30.0 mm − 112.0 mm
Tag 25.4 mm − 1500.0 mm 3”/sec., 6”/sec.: 30.0 mm − 1500.0 mm
B-SX4T
Label 38.0 mm − 1500.0 mm 3”/sec., 6”/sec.: 38.0 mm − 1500.0 mm
Tag 25.4 mm − 1500.0 mm
3”/sec., 5”/sec.: 30.0 mm − 1500.0 mm
8”/sec.: 38.0 mm − 1500.0 mm
Media pitch
B-SX5T
Label 38.0 mm − 1500.0 mm 38.0 mm − 1500.0 mm
Tag 0.15 − 0.29 mm
Media thickness
Label 0.13 − 0.17 mm
Cutter life
300000 cuts (0.274-mm thick tag paper)
1000000 cuts (0.160-mm thick tag paper)
Home position detection Micro switch Photo coupler
3.2 STRIP MODULE: B-9904-H-QM/QM-R (option for the B-SX4T)
This strip module consists of the take-up block and the strip block. Installing the strip module enables
the printer to not only remove labels from the backing paper, but wind the tag paper or label with
backing paper onto the take-up spool by using the rewinder guide plate. The rewind full sensor is
provided to detect the overflow if the wound tag paper or label exceeds the specified amount is provide.
3.3 RIBBON SAVING MODULE: B-9904-R-QM (option for the B-SX4T)
By moving the print head up and down with a solenoid, the ribbon saving module saves loss of the
ribbon as far as possible. It is small enough to be put into the print block.
3.4 RIBBON SAVING MODULE: B-9904-R2-QM/QM-R (option for the B-
SX4T)
This ribbon saving module uses the solenoid with stronger pull force, which improves the ribbon saving
function. It is necessary to upgrade the firmware to V1.2A or greater to use this module.
Swing: 32.8 mm
Rotary: 77.1 mm
Print Head
Pinch Roller
Feed Roller