Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33059
2.4 Loading the Media
E2- 6
2.4 Loading the Media
(Cont.)
10. Lower the Print Head Block until it stops.
11. After loading the media, it may be necessary to set the Media
Sensors used to detect the print start position for label or tag printing.
Setting the Feed Gap Sensor position
(1) Remove the Locking Screw that secures the Media Sensor.
(2) Manually move the Media Sensor so that the Feed Gap Sensor is
positioned at the centre of the labels. ( indicates the position of
the Feed Gap Sensor).
(3) Tighten the Locking Screw.
Setting the Black Mark Sensor position
(1) Remove the Locking Screw that secures the Media Sensor.
(2) Pull about 500 mm of media out of the front of the printer, turn the
media back on itself and feed it under the Print Head past the sensor
so that the black mark can be seen from above.
(3) Manually move the Media Sensor so that the Black Mark Sensor is
in line with the centre of the black mark on the media. ( indicates
the position of the Black Mark Sensor).
(4) Tighten the Locking Screw.
NOTE:
B
e sure to set the black mark
sensor to detect the centre of the
black mark, otherwise a paper
j
am or no paper error may occur.
Locking Screw
Black Mark Sensor
Black Mark
Feed Gap Sensor
Label
Gap
Locking Screw
Media Sensor
Media Sensor