Filter
Top Products
Error code Phenomenon Possible cause Items to confirm / Countermeasures Precautions / Remarks
EA70
EA60
CC30
CC41
- When more than one
sheet of paper is
loaded on the buffer
tray, the first sheet is
pushed out of the tray
by the second sheet.
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
transported from the
buffer tray to the
finishing tray, the
paper is run on the
front or rear alignment
plate.
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
finishing tray to the
movable tray, the
paper exit guide
catches the paper and
thus a motor error
occurs because the
paper cannot exit.
8. Stack transport motor belt out
of gear
If the stack transport motor belt is loose, retighten it, or replace the motor bracket (BRKT-MOTR-SF) to retighten
the belt.
7. Improper installation of
alignment plates
6. STAY-BUFFER deformed Remove the bracket of the buffer roller lift solenoid. Then check that STAY-BUFFER is not deformed using a
scale or other straight tool. Replace it if it is deformed.
If the front or rear alignment plate is removed or its installation is improper, reinstall it. (The alignment plates must
not be risen even if they are tilted to the right or left.)
STAY-BUFFER
Scale
A gap appears if it is deformed.
AbnormalNormal
Alignment plate
Rising of the plate
㪏