Filter
Top Products
Error code Phenomenon Possible cause Items to confirm / Countermeasures Precautions / Remarks
EAE0 1. Loose connection
(Loose connection may cause
false operation or detection.)
(Loose connection may cause
false operation or detection.)
Paper jamming A. Check if the interface cable of the Finisher is connected securely. Reconnect it if not.
B. Check if the connectors (CN12 and CN14) of the Finisher control PC board are connected securely. Reconnect
them if not.
The harness wiring must be under the screw and inside of the Mylar, and the
harness must be wired along with the groove of the plate as shown on the left.
Be sure that the harness is covered by the Mylar.
2. Movable tray paper exist
sensor harness (HRNS-SFTTRY)
short circuited
Check if the harness (HRMS-SFTTRY) of the movable tray paper exist sensor is short circuited or if its wiring is
proper. Replace the harness if it is short circuited.
C. Check if the connectors (CN1 and CN2) of the CNV board are connected securely and the locking support is
installed properly. Reconnect them if not.
Interface cable
Connector
Locking support
Abnormal
HRNS-SFTTRY (6LB12426000)
Connector
㪈㪇