Filter
Top Products
Error code Phenomenon Possible cause Items to confirm / Countermeasures Precautions / Remarks
EA70
EA60
CC30
CC41
11. Insufficient ejection of
front/rear transport roller
If the front and rear transport rollers are not ejected from the transport guide at 0.5 mm or more, replace the
trans
p
ort
g
uide
(
GUIDE-FEED-LOW
)
.
10. Abnormalities in paper
transport section
Check if there is any scratch, foreign matter, paper dust or remained paper that disturb the paper transport in the
p
a
p
er trans
p
ort section. Remove if an
y
.
- When more than one
sheet of paper is
loaded on the buffer
tray, the first sheet is
pushed out of the tray
by the second sheet.
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
transported from the
buffer tray to the
finishing tray, the
paper is run on the
front or rear alignment
plate.
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
finishing tray to the
movable tray, the
paper exit guide
catches the paper and
thus a motor error
occurs because the
paper cannot exit.
12. Wrong operation by users
during printing
An EA70 error may occur if paper exit is disturbed during printing.
Paper transport
section
0.5 mm or more
Transport guide
Rear transport roller
Front transport roller
㪹㪸
㪐