Filter
Top Products
Error code Phenomenon Possible cause Items to confirm / Countermeasures Precautions / Remarks
CC41
EA20
EA40
EA70
Be sure to draw out the sub-tray when large paper is used. Otherwise false
stacking, paper dropping or an EA70 error may occur.
5. Improper connection between
the equipment and the Hole
Punch Unit
(Paper is not properly transported
from the equipment to the Hole
Punch Unit if they are not
connected correctly.)
When the Hole Punch Unit is installed, check if the connection point is shifted forward or backward.
4. Improper exit of large paper Secure enough space for drawing out the sub-tray when installing the Finisher. If the Finisher is installed as
shown in the picture below, the trailing edge of large paper may be jammed when it is exiting.
- Paper jams at the
entrance section of
the Finisher (or the
Hole Punch Unit)
- Folded paper edge
- Improper closing of
the stationary tray
3. Tilted Finisher
(Paper is not properly transported
from the equipment to the
Finisher if the Finisher is tilted.)
If the Finisher is tilted as shown below, adjust the height of each caster to make the Finisher horizontal to the
e
q
ui
p
ment.
If the Finisher is tilted, the fixing screw of the Bridge Unit and the stationary tray
may be contacted when the stationary tray is opened or closed.
Normal
Abnormal
Bridge Unit fixing screw
Caster
Sub-tray
Wall
Normal
Abnormal
Hole Punch Unit
㪈㪋