Filter
Top Products
4 Replacement Procedures 4.9 Display Assembly
4.9 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable is not caught between the display
assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-18, 4-19.
1. Turn the computer so the rear is facing you and remove two M2.5x8 black flat head
screws.
2. Restore the normal computer placement and open the display panel.
M2 5x8 black flat head screw.
Figure 4-18 Removing the screws from the back of the computer
3. Disconnect the LCD/FL cable from CN1 on the system board
4. Disconnect the MIC cable from CN5 and the CCD cable from CN6 on the system
board
5. Remove four M2.5x5 white flat head screws securing the LCD module to the top
cover.
6. Remove the wireless antenna cables, MIC cable and CCD cable from the top cover.
7. Remove the display module.
4-38 Qosmio F40/F45 Maintenance Manual