Filter
Top Products
3 Diagnostic Programs 3.2 Quick Start
During the editing, user could press F2 to confirm the DMI attribute update or press F4
to ignore the modification. Press ESC to exit the program of DMI Write.
The confirmation screen is as below:
The attributes that have been modified would be marked in red; otherwise in yellow.
User could press F2 to save the changes, or press F4 to ignore and exit the current
program.
3.2.9 Finger Printer Detect Test
Both Finger Printer Detect and Finger Printer Scan refer to finger print test, which means
finger print identification system. Finger Printer Detect, a self test of finger print test,
detects the existence of the device. If it exists, the system will prompt a message of
PASS, otherwise the message will be FAIL.
3.2.10 Finger Printer Scan Test
In Finger Printer Scan test, the system scans a finger print for three times and
displays Succeeded if successfully collected finger print information. Then it will scan
the finger print one more time for comparison and display PASS if succeeded. If the
comparison is not successful, the system will request another scan for totally five times
and display FAIL if it always fails.
Note:
Because, execution of this test vanishes all fingerprint data. When you perform this test,
please make it only failure of a fingerprint sensor.
10
QosmioF40/F45，dynabook Qosmio F40 Maintenance Manual