Filter
Top Products
4 Replacement Procedures 4.17 Optical disk drive
4-44 [CONFIDENTIAL] QOSMIO G30 Maintenance Manual (960-546)
Installing the optical disk drive
The following describes the procedure for installing the optical disk drive (See Figure 4-24 to
4-26).
1. Installing the ODD rear bracket to the ODD assembly and secure it with the
following screws.
• M2.0×2.7B S-THIN HEAD screw ×2
2. Installing the ODD side bracket to the ODD assembly and secure it with the
following screw.
• M2.0×3S S-THIN HEAD screw ×1
3. Connect the ODD assembly to the connector CN1810 on the system board and
secure it with the following screw.
• M2.5×6B FLAT BIND screw ×1
4. Install the ODD panel and secure it with the following screws. (Only when the DVD
super multi drive is mounted.)
• M2.5×6B FLAT BIND screw ×2