Filter
Top Products
4 Replacement Procedures 4.5 Memory module
4-14 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)
Installing the Memory module
To install the memory module, make sure that the computer is powered off, follow the steps
below and refer to Figure 4-4 and 4-5.
1. Insert the memory module into the connector CN1460 on the system board slantwise.
CAUTION: Insert the dent of the memory module to the guide of the memory slot.
2. Press down the memory module until it is latched firmly.
3. Set the memory cover and secure it with the following screws.
• M2×4B STEP screw ×2
NOTE: When the power of the computer is turned on, the computer checks automatically
the memory size. Confirm that the new memory is detected correctly.
If the memory is not detected, check that it is connected correctly.