Filter
Top Products
4 Replacement Procedures 4.12 DC-IN jack
4.12 DC-IN jack
Removing the DC-IN jack
To remove the DC-IN jack, follow the steps below and refer to Figure 4-15.
1. Disconnect the DC-IN jack cable from the connector CN8800 on the system board
and remove the DC-IN jack from the slot.
Insulator
DC-IN jack
DC-IN jack cable
Guide
CN8800
Figure 4-15 Removing the DC-IN jack
Installing the DC-IN jack
To install the DC-IN jack, follow the steps below and refer to Figure 4-15.
1. Set the DC-IN jack into the guide of the slot and connect the DC-IN jack cable to
the connector CN8800 on the system board.
CAUTION: When installing a new DC-IN jack, stick a new insulator in place.
4-28 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)