Filter
Top Products
4 Replacement Procedures 4.21 Touch pad/Fingerprint sensor board
4.21 Touch pad/Fingerprint sensor board
Removing the Touch pad/Fingerprint sensor board
To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-33 and 4-34.
1. Turn over the middle frame and disconnect the TP cable from the connector on the
touch pad board.
2. Disconnect the FP cable from the connector CN9810 on the fingerprint sensor board.
3. Turn the middle frame face up and remove the touch pad adhered with the double-
sided tape.
4. Remove the touch pad button adhered with the double-sided tape while releasing the
latches.
Touch pad
Touch pad button
FP cable
TP cable
Latch
Touch pad board
Fingerprint sensor board
CN9810
Figure 4-33 Removing the touch pad/fingerprint sensor board (1)
4-54 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)