Filter
Top Products
26
Turning the power on and off
■ Connecting the power cord
1
Insert the power cord connector into
the AC IN socket of the projector.
2
Insert the power cord plug into a wall
or other power outlet.
■ Turning the power on
1
Turn on the main power switch.
The blue LED at the ON/STANDBY key will
start to fl ash, indicating standby mode.
2
Activate the projector.
The projector can be activated by pressing the
ON/STANDBY key on control panel for 3~5
seconds and releasing while the red LED is
still lit. The projector is only activated by the
ON/STANDBY key while the red LED is lit to
prevent unwanted starting of the projector.
When started all the blue LED on the control
panel will light up and the Start-up screen will
display.
The projector can be activated by remote con-
trol, too. In this case, it is no need to press the
ON/STANDBY key for 3~5 seconds.
WARNING
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fi re due to internal
overheating.
• Do not place your hands, face, or any other objects near the air exhaust. Doing so
could cause injury or could deform or break the object.
• Turn off AC switch before plugging out power cable.
Power cord
connector