Filter
Top Products
47
Operations
Setting fan mode to high increases the cooling fan speed. Set this option to use the pro-
jector at high altitude (over 1800 meter / 6000 feet above sea level)
Press
. Select from Standard/High with / [UP] [DOWN] key.
Projection mode
Sets projection mode in accordance with placement style.
p.22
The following four modes are available.
- Standard
- Ceiling (TDP-ET10 only)
- Rear
- Rear ceiling (TDP-ET10 only)
Press
. Select with / [UP] [DOWN] key.
Keypad light
Set keypad light on or off.
Press
. Select from On/Off with / [UP] [DOWN] key.
Reset
Reset Setup MENU adjustments and settings to factory default.
Press . Confi rmation window will appear and select [Yes] with / [ - ] or / [ + ] key
and press
to reset.
Reset all
Resets all adjustments and settings except language to factory default.
Press
. Confi rmation window will appear and select [Yes] with / [ - ] or / [ + ] key
and press
to reset.
■
Status display MENU
Video
Display video signal information of current input signal.
H-frequency
Display Horizontal sync frequency of current input signal.
V-frequency
Display Vertical sync frequency of current input signal.
Audio
Display audio signal information of current input signal.
Lamp time
Display time of lamp use.
Displays lamp time as a measure of when the lamp should be replaced. (Cannot be used
as a counter of guaranteed lamp time) When displayed time approached approximate
2,000 - 3,000 hours, consult with a store about getting a TLPLET10 replacement lamp (sold
separately) prepared.