Filter
Top Products
20
User Controls (Continued)
Loading dry-cell batteries into
the remote control
1.
Remove the battery cover.
2.
Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
3.
Replace the battery cover.
Operating the remote control
Point the remote control toward the
projectorfs infrared remote sensor, and
press a button on the remote control.
• Operating the projector from the front
• Operating the projector from the rear
Dry-cell batteries
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the
batteries with new ones.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fl uorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control.
If this happens, point the remote control at the main unit again, and repeat the
operation.
Preparing and using the remote control
Approx. 5m
Approx. 5
m
Approx. 15°
Approx. 15°