Filter
Top Products
TL-WPA4220/TL-WPA281 300Mbps AV500/AV200 WiFi Powerline Extender
5
2.3 Physical Interface
There are four physical items on this device.
Item Description
Wi-Fi/Wi-Fi
Clone Button
Press the button for 2 seconds to start Wi-Fi Clone.
Press the button for 5 seconds to enable or disable the wireless function.
Ethernet Port Two 10/100Mbps Ethernet port connected to PC LAN card or broadband device.
Reset Button
Press the button more than 5 seconds, the device will restore to its factory
defaults.
Pair Button Pair buttons are used to secure a powerline network.
)
Note:
1. If you press the Pair button for more than 10 seconds, the extender will leave the network it is
associated with and its network name assumes a random value.
2. For detailed information about the Reset button and Pair button, please refer to Chapter 5 Pair
Buttons.
2.4 Hardware Connection
Please first make sure that your PC can successfully access the Internet via the router. Then connect
the powerline devices by following the instructions below.
Step 1: Connecting to the Internet
This section describes how to connect the powerline extender into your existing network. Follow the
procedures described below:
1． Connect one end of an Ethernet (RJ45) cable to the Ethernet port of the powerline extender or a
compatible powerline adapter like TL-PA4010.
Wi-Fi/Wi-Fi Clone Button
Ethernet Port
Pair Button
Reset Button