TP-Link TL-SG2008 Switch User Manual


 
13
Predefined Mode: Select a predefined DST configuration.
z USA: Second Sunday in March, 02:00 ~ First Sunday in
November, 02:00.
z Australia: First Sunday in October, 02:00 ~ First Sunday in
April, 03:00.
z Europe: Last Sunday in March, 01:00 ~ Last Sunday in
October, 01:00.
z New Zealand: Last Sunday in September, 02:00 ~ First
Sunday in April, 03:00.
Recurring Mode: Specify the DST configuration in recurring mode. This
configuration is recurring in use.
z Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
z Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Date Mode: Specify the DST configuration in Date mode. This configuration is
recurring in use.
z Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
z Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of Europe in predefined mode.
4.1.5 System IP
Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three modes
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode
will replace the original IP address. On this page you can configure the system IP of the switch.
Choose the menu SystemSystem InfoSystem IP to load the following page.
Figure 4-7 System IP
The following entries are displayed on this screen: