Filter
Top Products
199
Command Mode
Global Configuration Mode
Example
Specify Hold Multiplier as 5:
TP-LINK(config)# lldp hold-multiplier 5
lldp timer
Description
The lldp timer command is used to configure the parameters about
transmission. To return to the default configuration, please use no lldp timer
command.
Syntax
lldp timer tx-interval tx-interval
lldp timer tx-delay tx-delay
lldp timer reinit-delay reinit-delay
lldp timer notify-interval notify-interval
lldp timer fast-count fast-count
no lldp timer tx-interval
no lldp timer tx-delay
no lldp timer reinit-delay
no lldp timer notify-interval
no lldp timer fast-count
Parameter
tx-interval —— Configure the interval for the local device to transmit LLDPDU to
its neighbors. By default, it is 30 seconds.
tx-delay —— Configure a
value from 1 to 8192 in seconds to specify the time for
the local device to transmit LLDPDU to it
s neighbors after changes occur so as
to prevent LLDPDU being sent frequently. By default, it is 2 seconds.
reinit-delay ——This p
arameter indicates the amount of delay from when LLDP
status becomes "disable" until re-initialization will be attempted. The default
value is 3.
notify-interval —— Specify the interval of Trap message which will be sent from
local device to network management system. By default, it is 5 seconds.
fast-count ——When the
port's LLDP state transforms from Disable (or
Rx_Only)