Filter
Top Products
68
transmission speed of the legal ARP packet on the port exceeds the defined
value. To restore to the default speed, please use no arp detection limit-rate
command.
Syntax
arp detection limit-rate value
no arp detection limit-rate
Parameter
value ——The value to specify the maximum amount of the received ARP
packets per second, ranging from 10 to 100 in pps(packet/second). By default,
the value is 15.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the maximum amount of the received ARP packets per second as 50
pps for the port 5:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# arp detection limit-rate 50
arp detection recover
Description
The arp detection recover command is used to restore to the port to the ARP
transmit status from the ARP filter status.
Syntax
arp detection recover
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Restore the port 5 to the ARP transmit status:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# arp detection recover