Filter
Top Products
201
lldp snmp-trap
Description
The lldp snmp-trap command is used to enable the ports' SNMP notification. If
enabled, the port will notify the trap event to network management system. To
disable this function, please use no lld
p snmp-trap command.
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the ports' SNMP notification for port8:
TP-LINK(config)# interface ethernet 8
TP-LINK(config-if)# lldp snmp-trap
lldp tlv-select
Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lld
p tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp tlv-select [port-description] [system-capability] [system-description]
[system-name] [management-address] [port-vlan-id] [protocol-vlan-id]
[vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all]
no lldp tlv-select [port-description] [system-capability] [system-description]
[system-name] [management-address] [port-vlan-id] [protocol-vlan-id]
[vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all]
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing
from port 8: