TP-Link TL-SG5428 Switch User Manual


 
44
Chapter 10 LACP Commands
LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can
dynamically group similarly configured ports into a single logical link, which will highly extend the
bandwidth and flexibly balance the load.
lacp system-priority
Description
The lacp system-priority command is used to set the system priority. To
restore to the default priority, please use no lacp system-priority command.
Syntax
lacp system-priority value
no lacp system-priority
Parameter
value —— System priority, ranging from 0 to 65535. By default, the value is
32768.
Command Mode
Global Configuration Mode
Example
Set the system priority as1024:
TP-LINK(config)# lacp system-priority 1024
lacp (interface)
Description
The lacp(interface) command is used to enable LACP protocol on the current
port. To disable LACP protocol, please use no lacp command.
Syntax
lacp
no lacp