Filter
Top Products
Getting Started
Trango Broadband Wireless — User Manual M2400S Rev. A
Page 9
Link Control: This page shows which SUs are associated. This page also provides several tools for evaluating the
quality of the wireless link.
Command Console
: From this page, the user can run any console command that is not interactive (i.e. ipconfig)
or time sensitive (su linktest). For a complete list of console commands, type help or ? in the entry field.
Logout
: This link will end the current browser session with the radio.
Help
: The Browser Interface features useful Help pages which explain all listed parameters. To access the help
pages click on the Help link.
Command Line Interface
Although most radio functions can be managed via the browser interface, the command line interface (CLI)
provides slightly more functionality and is usually the management tool of choice for experienced users. The CLI
can be accessed through Telnet.
Telnet
Open a command prompt (DOS) session on your PC. Open a telnet session by typing:
telnet [ip address of radio]
All Trango radios are pre-configured at the factory with a default IP address of 192.168.100.100. The factory
default password is trango. Once you connect to the radio you will be greeted with current hardware and firmware
information and prompted for a password. Type in the read-write (RW) password and press enter.
Example:
C:>telnet 192.168.100.100
Welcome to Trango Broadband Wireless M2400S-AP 1p0X21H0006D04081903
Password:
#>
To terminate a CLI session (Telnet or Serial) type the command logout.
! Note: Type help or ? for a listing of all CLI commands. Type help <command> for the syntax of a particular
command.
Example (to view a list of all commands that start with su)
#> ? su
su [all | <suid, 1..126>]
su info <suid, 1..126>
su linktest <suid, 1..126>
su password <suid|all> <rw|ro> <new password> <new password>
su ping <suid, 1..126>
su reboot <suid|all>
su sw <suid|all> <sw#, 0..7> <on | off>
su testrflink <suid, 1..126> <r>
su testrflink <all> <r>
sudb add <suid, 1..126> <pr|re> <device id,hex>
sudb cirmir <<suid>|all> <cir dn> <cir up> <mir dn> <mir up>
sudb defaultcirmir [<cir dn> <cir up> <mir dn> <mir up>]
sudb delete <<suid>|all>
sudb dload
sudb gid <<suid>|all> <0..15>
sudb view
survey <time, 1..10 sec> <antenna, h|v|e>