Filter
Top Products
Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual M2400S Rev A
Page
18
SU Ranging Test
This test reports the SUs distance
from AP in miles, received signal
strength for uplink and downlink,
and SU TX Power. Use a link budget calculator to analyze results. Significant differences between calculated and
actual values could indicate alignment or LOS issues!
Advanced Setup Page
The advanced set up page includes several important parameters including RF TX Power, RF RX Threshold,
target RSSI from SU (AP only), and Channel Table.
RF TX Power: Sets the conducted RF power output of the radio. Highest allowable setting is +23 dBm.
Lowest setting is +10 dBm. This value does not include antenna gain.
RF RX Threshold: Sets the receive threshold of the radio. The radio will not process signals received below
this level, so it is very useful for interference mitigation. For a smaller radius of
operation, use a higher threshold (-75 is higher than -80).
Target RSSI from SU: Used by the powerleveling process to automatically adjust the RF output power level of
all SUs in a sector so the signal strength from each SU, as measured at the AP, will be
roughly equal.