Filter
Top Products
Trango Broadband Wireless — User Manual M2400S Rev. A
Page
40
Appendix A Command Set Reference
(ro = read only access, rw = read write access)
Command Radio Description Access
? AP/SU
Display complete list of commands and syntax ro/rw
? <command> AP/SU Display specific command syntax ro/rw
antenna AP/SU Display current antenna setting
(h=horizontal, v=vertical, e=external )
ro/rw
antenna <e | h | v> AP/SU Select antenna mode
(h=horizontal, v=vertical, e=external)
rw
aprssi <ch#> <antenna, h | v | e> AP/SU Scan two strongest APs
(Opmode “OFF” only)
ro/rw
apsearch AP/SU Scan all channels to look for APs
(Opmode “OFF” only)
ro/rw
arq AP/SU Display current ARQ settings ro/rw
arq <on|off> AP/SU Enable/disable ARQ rw
bye AP/SU Same as “logout” ro/rw
eth link AP/SU Display current Ethernet setting ro/rw
eth link <100fdx|100hdx|10fdx|10hdx|aneg> AP/SU Change Ethernet duplex setting rw
exit AP/SU Same as “logout” ro/rw
freq AP/SU Display current channel ro/rw
freq <ch#> AP/SU Change current channel rw
freq channeltable AP/SU Display channel table ro/rw
freq writechannel [<ch #> <freq>]… AP/SU Modify center frequency of channel.
<ch #> = 1..8
<freq> = 2405..2475
Note: This command automatically writes to flash memory.
rw
help AP/SU Display complete list of commands and syntax ro/rw
help <command> AP/SU Display specific command syntax ro/rw
ipconfig [<new ip> <new subnet mask> <new
gateway>]
AP/SU Assign radio’s IP, subnet mask, and gateway IP rw
linktest <txrx|rxtx> [<pkt len, bytes> [<# of
pkts> [<# of cycle>]]]
AP/SU Loopback test to check quality of the wireless link. Variable
parameters include:
pktlen = 64..1760,
# 0 pkts = 1..500
# of cycles = 1..100000
ro/rw
logout AP/SU Log out of radio ro/rw
maclist AP/SU Display current MAC table (MAC addresses of attached devices) ro/rw
maclist reset AP/SU Display or reset current MAC table ro/rw
mirth AP Display MIR (Maximum Information Rate) Threshold ro/rw
mirth <0..3, Mbps> AP Assign MIR Threshold
default = 3 Mbps
mirth 0 = Always On
mirth 3 = Disable MIR Threshold
rw
opmode AP/SU Display current Opmode ro/rw
opmode on [<y>] AP/SU Set Opmode to be “ON” and use “y” if Opmode is not as same as
default Opmode
ro/rw
password <rw|ro> <new pwd> <new pwd> AP/SU Specify new password (max 15 octs)
rw=read/write password, ro=read only password
rw
ping <ip address> AP/SU Ping local Ethernet device
Note: This command only works for local Ethernet devices, not SU
or any device behind SU.
ro/rw
power AP/SU Display current TX power level
default = max. power value
ro/rw
power set <min|max|<dBm> AP/SU Specify TX power for both band
Note: SU’s power will be adjusted by AP during association process
(power leveling)
rw