Filter
Top Products
Basic Configuration via CLI
Trango Broadband Wireless — User Manual M2400S Rev A
Page
23
AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter Description Related CLI Command
MIR Threshold (Kbps) User specified MIR Threshold.
To specify total throughput
level that the AP will serve only
CIR (committed information
rate) to associated SUs.
When MIR Threshold is
disabled, the AP will serve MIR
for all its SUs.
When MIR Threshold is
activated, and the network
traffic exceeds the MIR
Threshold, the AP will only
serve CIR for all its SUs.
When MIR Threshold is
activated, and the network
traffic does NOT exceed the
MIR Threshold, the AP will
still serve MIR for all its SUs.
mirth [<0..3, Mbps>]
Example:
#>mirth 2
Active Channel Current RF channel
freq [<ch#> <v|h>]
Example:
#>freq 3
This command will change the channel of the AP to
3.
Antenna Current antenna selection:
(h)horizontal, (v)vertical,
(e)external
antenna [<v|h|e>]
RF RX Threshold Specifies the receiver
sensitivity of the AP. It is a
powerful tool when the radio is
in a noisy environment. AP
will block out any signal
received which is below the RF
Rx threshold. Separate settings
exist for both ISM and UNII
bands.
rfrxth <-90|-85|-80|-75|-70|-65>
example:
#>rfrxth –70
RF TX Power Current transmit power of the
AP not including antenna gain.
power <set> <min|max|<dBm>
Example:
#>power set 10
Channel Table Assigned frequencies to
channels. All channels may be
re-assigned as desired by the
administrator.
freq writechannel [<ch#> <freq>]
Example:
#>freg writechannel 3 910
This command will change channel 3 to 910 Mhz.
Broadcast Packet Filter This software switch (0)
enables/disables the blocking of
Ethernet control packets, except
ICMP and ARP, to reduce the
amount of unnecessary
overhead introduced to the
wireless link.
sw 0 [<on|off>] (default is on)
Example:
#>sw 0 on
note: All switch settings (0-7) are set using the sw #
[<on/off>] command.
SU to SU This software switch (3)
enables/disables the SU to SU
feature. When SU to SU is
turned on, multiple SU’s within
sw 3 [<on|off>] (default is off)
Example:
#>sw 3 on