Filter
Top Products
Getting Started
Trango Broadband Wireless — User Manual M2400S Rev. A
Page 5
• Connect a Cat-5 (straight through) Ethernet cable (we recommend shielded twisted pair) between the
Radio port of the J-box and the RJ-45 connector on the radio. Note: this cable will carry power-over-
Ethernet (PoE).
• NETWORK port connection is as follows:
If connecting to a COMPUTER, use a Cross-Over
Ethernet cable from the NETWORK port of the J-box
to the computer’s Ethernet port.
If connecting to a HUB, SWITCH, or ROUTER, use a Straight-Thru
cable.
• Plug the AC adapter into an AC outlet.
• Use Ground Lug to ground PoE device and shielded CAT5.
• Use voltmeter contacts to check line voltage (can be done with or without load).
CAT-5
STRAIGHT-THRU CABLE
20 VOLT POWER
SUPPLY
AC POWER
M2400S (AP o
r
SU)
POWER-OVER-ETHERNET
J-BOX
INDICATES POWER TO RADIO
INDICATES POWER TO J-BOX
USE STRAIGHT-THRU CABLE
USE CROSS-OVER CABLE
IF TO COMPUTER
IF TO HUB, SWITCH, OR ROUTER
CAT-5
NETWORK
OR
COMPUTER
GROUND
LUG
VOLTMETER TEST LEADS
VOLTMETER TEST LEADS
Figure 6: Wiring Diagram
Both green LEDs on the J-box should be lit, indicating power is present at the J-box as well as the radio.
You are now ready to configure the radio via the Ethernet port.
Radio Management Concepts
Proper connections to the radios and careful IP/routing & planning will enable the network administrator to access
and manage the radios remotely over the network via TCP/IP. Radio management over TCP/IP can be performed
from computers connected to the Ethernet side of each radio. Computers connected to the AP can manage the SU
over their wireless connection. Likewise, computers connected to the SU can manage the AP, provided that switch
7 (TCP/IP access to AP from SU) is enabled on the AP. Switches will be covered later in this text.