Filter
Top Products
Appendix C: Device Commands & Definitions Transition Networks
Command Description
ifoam port=<portno> OAM configuration for the specified port.
Usage: ifoam port=<portno>
[oam=enable|disable]
[oammode=active|passive]
[oamrmtloop=enable|disable]
OAM: OAM can be enabled/disabled.
Oammode: OAM Mode can be set to Passive/Active
Mode.
Oamrmtloop: OAM loopback can be enabled/disable
on the remote Device peer.
netstat Displays all active and passive sockets.
ping Pings the host to check if it is reachable using ICMP
requests.
ps Displays the system processes.
reboot Saves the current configuration and reboots the system.
save Saves the current configuration to non-volatile memory.
set Sets network settings and system configuration.
Usage: set
[dhcp=<enable|disable>]
[ip=nn.nn.nn.nn]
[netmask=nn.nn.nn.nn]
[gateway=nn.nn.nn.nn]
[trapmgr=nn.nn.nn.nn]
[community=<"value">
(max=64)
]
[groupstring=<"value">
(max=64)
]
[radius=<enable|disable)]
[radiusip=nn.nn.nn.nn]
[radiussercret=<"value">
(max=64)
]
[username=<"value">
(max=64)
]
[password=<"value">
(max=64)
]
[usb=<enable|disable>]
[l3capability=<enable|disable)]
[snmpaccess=<enable|disable)]
[tftpserver=nn.nn.nn.nn]
[tftpfile=<"value">
(max=64)
]
[mgmtvlan=<vlanid>
(2-4096)
set autoupg Enable/disable auto upgrade.
When enabled, automatically upgrades the firmware.
Usage: set autoupg=<enable|disable>. This locks/unlocks
firmware upgrades from an active OAM Device peer.
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 123